Configure DC Local Server Mode
You can find the configuration files here:
The server usually works with the system user.
You can find the files in the 'Root' directory. If you change the running user, follow the 'User' directory to find the files.
Before you use DC Local Server Mode with a new Org, you need to change some settings in the properties file, located in:
Set batch profile
The batch profile setting determines how many resources DC Local will take up on your machine. The higher you set this, the quicker the jobs get processed. When set to 'High', DC Local will take up the maximum amount of resources to run jobs. If you have multiple processes running on your server, pick a lower setting.
Set the environment
To establish a connection, DC Local needs to know which environment it will work with: Production or Sandbox. The default setting is Production. Make sure that the environment mentioned in the file matches your Salesforce environment.
You can also set the environment to Custom so you can only log into the server through a custom URL. In that case, also set a custom domain to use for logging in.
Set an email address
Optionally set one or more email addresses to receive information when something goes wrong. Separate them with commas.
See below for an example of the configuration file where the environment has been set to Sandbox and two email addresses to receive information have been set. Lines with a '#' in front of them are commented out. Make sure to remove the '#' to activate the setting.
# Plauti DC Local configuration file
# Low | Medium | High
# Salesforce Org Type; PRODUCTION, SANDBOX or CUSTOM
||Look up the verification URL in the log file. Navigate to the URL.
||The connection page will ask you for a verification code. Find the code in the log file. Enter it on the page and click 'Connect'.
||Salesforce asks you to allow access to Duplicate Check. Click 'Allow'.
||You are connected.
You can stop DC Local using the following commands:
Once you have authenticated yourself, you can restart the service without new authentication. If you want to log in as a new user, delete the file 'console-app-session.pla', restart the server, and follow the steps above again.
You can check the status of the DC Local server by doing the following:
Go to Services.